I need full flash,eprom to dashboard Volvo V70 2005-07,MC9S12DG128,white connector.
Hi to all members working on a oshkosh mixer truck with a cummins m11 engine ,truck was on a job ran fine after sat for about a year with out starting now try to start truck it will start an run for a few seconds an cut off used insite scan engine found code 132 low voltage did all the steps in the troubleshooting guide change tps also change wires from tps to ecm connection ,took ecm an try on a next truck an truck started an ran .
truck is a 1998 model tanks
I have Mercedes Actros truck which is import from Europe, Its speed limit adjusted @90 I want to reduce @75, but there is list for only selection speed limit like 40, 70, 80, 85, 90, 95, 110 till 125. Our Gulf spec vehicle there is option to set by putting digit by our self. How can I adjust @75 have any idea please share with me.
Hi. I just bought a VMWare image (and associated HW) of Xentry/DAS. I just want to use DAS and it doesn't seem to recognize any License key, as it just keeps prompting for a name and key when i try to run it. MB Star utils does like (and let me save) the key, but the DAS program always asks me for one. Any help is appreciated. FYI:
HW fingerprint is:
LAN ID is:
DAS version is:
DVD Version is:
R2.0 V 09 2012
Hello guys. I want to buy the any Dash board VNL 670 for the good price. Who that has, write.
Xprog BDM adapter. Black GND, Purple BKGD,Yellow Reset,Red VDD +5v,Coaxial Blck GND,Gray Extal.
Xprog device list 9S12 eprom,flash secured.
I got a Citroen C5 V6 petrol engine Model 2001,VIN NO: VF7DCXFXF76xxxxxx,Airbag ECU: TEMIC 96.419.683.80.
A month ago a truck smashed rear of my car and made a lot damage.
Both front seatbelt pretensioners went off and now shows Airbag fault.
For 10 days car is at a Citroen dealer, scanner shows fault code: P10E0, they do not know watt is the code and waiting for answer from Citroen France.
I wonder do anybody in forum know this code or watt need to be changed on car to clear Airbag fault.
All suggestions appreciated, regards tony.t.
hi all mhh members
I'm searching about how to programming a MB key ?
what is the tool that i should use ? :|
how to use ?
there are two possibilities :
1 - the key is lost
2- copy a key
i'm asking how ??
explain in details
give me pdf file
advice me what i can do .
all b40 and 50
pass by pm
pass by pm
We are looking for a cruise control wiring diagram for a 2000 ih 9100i.
Anybody have a sheet they can scan and throw up? We have a dead short somewhere.
Does anybody has any kind of diagnostic tool/software for Raymond forklifts ?.
I completed an OBD read and had the OBD read tuned.
However I am doing the flash over BDM which means I will need to inject the calibration data into the file.
So I would like the damos to ensure I am only copying calibration data and not accidentally overwriting operation/cks data.
Sent from my GT-I9505G using Tapatalk