I have DAF 105XF 430, which have before a automatic gearbox Zf astronic. The gearbox is broken we replaced with manual one, now the truck have black smoke and power lost. After scanning with davie we two fault code:
-U0101 Can communication ( message rate from transmission too low,
-U0103 can communication (message rate from transmission too low.
Theses fault codes can cause engine black smoke? Can I reprogram with davie and change astronic in VIC with manual one? Thanks in advance for any help? [/font]
I have a 2005 E64 630ci giving me a headache
1st AL module had code - 006131 AL: Control unit flash operation or NEC Errror
Now on 2nd used AL, attempt to program with ISTA-P, keeps on saying to replace.
Fault codes 006142 AL: ECO valve : fault
006143 AL: Servotronic valve: fault
Have checked resistance of ECO valve 8 Ohms at valve & 8 Ohms at Safety/Gateway module.
i need help about problem in gearbox automatic
i drive the car suddenly it stops can change the gearbox and 2 light on in dash :Brake stationnt and light green of pedale it in the road it drive until i delete fault code in Brake stationnt:
any help please
thanks in advance
I have this problem:
The car was crashed and the ECU is broken (the pcb is bend).
The engine couldn't start. I read full ecu with galletto in bootmode, but considering that my galletto is a clone, i can't write the internal flash because of the checksum, so i will try to adapt the "new" ecu with VCM II v86.
Can someone help me with incode/outcode for this new model of Mondeo?
Thank you !
I removed ecm from a 2012 dodge ram, 6.7l cummins with dpf and egr.
I want to remove these shits and tune. Read by ktag 6.07, modified. but. can't write back. "Operation not allowed". then someone talked that i need to remove boot protection. but how?
someone was experience on this?