I've been looking for the EGR maps on this and have come across 2 sets of 3 maps which I think are the EGR maps. Are these what needs to be edited to turn off the EGR? If so can someone tell me what to do please?
New Nissan Infiniti PIN Code Calculator 4.0 BCM IMMU to PIN
Unlimited BCM & IMMU to PIN 2006-2012 (OLD+NEW)!
You can calculate immobilizer code by encrypted code from BCM (and IMMU) label - 5 digit code
BEST BCM (Body Control Module) to PIN CALCULATOR! FAST CALCULATION! Get your PIN within 6 seconds.
Six Reasons to buy/purchase:
#1 Cheapest! SAVE MONEY.
#2 No token limited! UNLIMITED CALCULATIONS
#3 Easy-to-Use! 1). Just run the software , 2). Enter BCM code , 3) Press "Calculate" button
#4 No Dongle Required!
#5 No Shipping, JUST A DOWNLOAD LINK (small size)! SAVE tIME!
#6 Also works for 2009 and newer models
Questions? Email email@example.com . NO PM, inbox is full!
I've been searching the web and all forums on offline programming and there seems to be confusion. Is it SCN coding offline or is it offline programming.
I have successfully installed 03.2012 and 07.2012 with all the fixes and standalone DAS. I am able to access offline SCN coding but to do control unit programming it only shows online, am I doing something wrong or is SCN coding what everyone refers to as offline programming??
Then when I get on to do offline coding it asks for a CD or manual entry of coding string. I have used the install disks to no avail and have reviewed and corrected my inbetrieb.ini to F:/ and still nothing. After weeks of online searches and nothing concrete I am turning to the forum members to see if anyone can help.....
Done a Can read using galletto 2 and now have a 2mb read but need to make it virgin or change the vin. tried Mercedes ecu editor but it doesn't recognize my dump any help would be great ive also attached my dump hoping someone might be able to look and tell me if its read OK
I have a little problem with immo off in this driver.
When i want turn it off, at first time motor start ok , and everything looks good.
No errors in driver... and motor works ok.
When i turn on the motor second time after some time,
motor do not start, and i have an error in driver.
Error about driver blocked by immobilizer ofcourse ...
and my changes in memory is overwrite by driver...
I was tested a few combination of change bytes ...
Did someone have some idea for this driver ?
excluding emulator ..
I send oryginal read from memory...
Please check it...
Hello all, I have a working Mitsubishi Mut 3 tool but no software, all the software found when install is complete offer xentry tool or sdconnect as choice no Mut 3. Do you know if I have wrong software or how to configure to use with Mut 3. During software installation no option to choose tool.