I need EGR OFF.
Peugeot Partner 1.6HDI 2008
Engine: 9HX 90HP
Thank for advanced
Hello all i am interesing to find the zusb of bmw e61 523i 2006 it need the original data for 523i i post the dme
Sent from my GRACE using Tapatalk
Ok I'v installed Mercedes Wis but I don't want to fill my hard drive so opted to use the 2 dvd discs when prompted. What I would like to do is copy the two DVD disc's to an external hard drive then get the program to look at the external drive instead of wanting me to swap dvd's all the time.
Any ideas how best to do it (if it can be done)?
Hello @ all
How about converting from sgo to bin?
Witch program or tool can do it?
Thank you all.
Hello there, i wonder if anybody can help me point out what ktag family and protocal on ksuit? I using ktag but i can not find the pin out to connect to ecu. Any help greatly appreciated...
1999 ford expedition gasonline engine v8.
Sorry if my post is the wrong place...
can anybody send me help files for kess?? thanks in advance
I need stage 1 for Audi A3 8P siemens 03G906018DH. PPD 1.2
thank you in advance
Hi , someone can help me make dpf off in this file ?? i try with ecusafe and dpf remover 3.0 but the car is in sleepmode in 3000rpm.....
can any help me ?
Can anyone measure the original ABRITES antenna resistance?
I need software INSITE CENSE to access CENSE system in Cummins Engine KTTA50 and how I can reprogram the modul.
Thanks a lot.
I have a truck that the ABS ECU went bad (pins rotted off ecu) i bought a new unit but it has to be programed, went to there web site and they want 325 for the config.file Is there any other way to program this thing?
Got a f20 with the CIC stolen and A/C...
Been spending ages going through different ways of doing it assuming its pretty straight forward with ESYS but will i need FSC coding as well?
In case i get stuck is there anyone on here doing it via team viewer?
after adding new chineese key, car wont crank always...
i have add new key with Tango from ews file readed with XProg clone and not needed to put any dump back to ews and write..
now car, very often, wont start and on diagnose have error' rolling code dont match' or wrong code..
any idea what could be a problem?
thnx in advance...
I am a new friend. I have some years of experience in the diagnostic repair of Mercedes & BMW vehicles. I wish to contribute with my best, my knowledge to this group and also to learn something new here from the experts.
Just replaced my rear park sensors. Vcds shoved me tat the rear mid right and left sensors were broken. Bought 4 new ones, and replaced all 4 rear parking sensors.
Now when i put my car in reverse, they constantly keep beeping. And on the screen it shows as if theres something near all the sensors..
Do i need to recalibrate anything? I have tried deleting dtc's, but still same. The
Front ones work ok.
Car: q7 2007
Need help to program Launch Control on my VW 1.8T ME7 , can anyone do these?
officially just cant figure out how to scan/pull codes using ptt have it all installed says its connected to truck via usblink when i click diagnose goes to next screen click the start button opens new screen nothing comes up probably doing it wrong but ive never use it before so theres probably my problem i did not notice its coming up as electric system as 98 older which probably isnt right either since its a 2010....
any help would be great thanks
I have problem with ezs from w203. I suspect that x-prog damaged my flash dump, can someone help me and give me this flash file?
EZS part no. 2095451908.
MCU mask: 4L40K.