I own a '01 Almera 2.2 dti, 81kw 110hp vp44 fuel pump gt1549s turbo.
I read my ori file and made some changes using winols after watching the vagecu youtube videos and lot of forum posts.
Could someone check if i did everything right and the file is safe to write?
Ecu is EDC15m+. I wanted around 15-20% increase.
Changed smoke map, torque map and boost map and also driver's wish a little. Boost limiter is unchanged, SVBL is changed to 2150. Corrected checksum too.
Are my boost values okay?
Also, can someone help me turn EGR off? I'm not sure which map is it.
I ask this Question already in another (wrong) Forum, sorry for the double-post.
Can somebody tell me how to display the remaining liters of Fuel in Instrument Cluster. It Shows only the remaining Kilometers. Is it possible to change it with Xentry?
hello guys, had a call from friend who just repaired his auto transmsission. car was driven in and after trans was replaced, the key light started to flash, which to me sounds like key lost its code. they sent me pic of dash with ign on and i could see that the mil light was not on and therefore diagnostic was no communication. all fuses were checked but still no mil light and no comms. im suspecting that battery boost was done incorrectly by fitters and could possibly have blown ecu (diode). any thoughts, have not been to the car as yet
I have a clone nexiq usb1 and i am unable to connect on multiple trucks with 2 different laptops. I think it may be a compatibility issue with the adapter. Does anyone know of any issue or of an adapter that works? I have searched everywhere but havnt come across anything yet. Adapters that I am aware of DPA5, Jpro DLA+, Nexiq 1, 2, NEXIQ Truck Diag King Thanks.