Quantcast
Are you the publisher? Claim or contact us about this channel


Embed this content in your HTML

Search

Report adult content:

click to rate:

Account: (login)

More Channels


Showcase


Channel Catalog



Channel Description:

MHH AUTO - https://mhhauto.com

older | 1 | .... | 379 | 380 | (Page 381) | 382 | 383 | .... | 4895 | newer

    0 0

    can anybody help me please to cleat crash data from dump?
    it´s dacia sandero 2009 ecu renault continental temic 8200946126 eeprom 95160. thanks before...

    dacia.zip
    File Type: .zip
    Downloaded: 1 times
    Size: 1,020 bytes


    0 0

    Hi

    i have a problem with BMW 5 series ABS/DSC control unit.
    i changed the ABS control with Pump motor.
    now it need to be reprogram the ecu did anyone know how to reprogram it.

    thanks

    0 0
  • 11/05/14--00:43: opel cdr500
  • HI,
    please code for opel astra G 2001 vdo cdr500 24c16

    cdr500 opel astra g 2001 24c16.rar
    File Type: .rar
    Downloaded: 3 times
    Size: 1.45 KB


    0 0
  • 11/05/14--00:58: Porsche PDK fluid change
  • Dear All,
    Can someone send pictures of PDK transmission fluid change as there are two types as per the manual, also if anyone can give an advice on an alternative to Pentosin FFL3;

    From the owners manual

    PDK transmission oil - approx. 3.12 quarts / 2.95 liters ATF transmission oil Mobilube PTX Formula A (SAE 75W-90) GL 4.5 - change at 120K miles or 12 years

    PDK clutch oil - approx. 5.49 quarts / 5.2 liters Pentosin Gear Oil FFL 3 - change at 60 K miles or 6 years

    I also found these steps but need more pictures of the drain plugs;

    Oil filling
    The correct hydraulic oil level is important for operating the transmission without
    running into problems. The following preconditions must be met in order to check or
    correct the oil level:
    • Engine must be idling
    • Vehicle must be horizontal in both longitudinal and transverse axis
    • Hydraulic oil temperature between 86° F. and 104° F. (30° C and 40° C)
    • Selector-lever position “P”
    • Clutch cooling volume flow must be switched off (using PIWIS Tester in Oil fill
    mode)
    • Retain the described states for approx. 1 minute to allow the oil to settle
    • Open screw plug on oil overflow bore and collect emerging oil until only drops of
    oil are emerging
    • Once there is no more oil emerging, top up the clutch fluid until oil emerges at
    the oil overflow bore
    • To avoid damaging the clutches, the procedure must be completed within 5 minutes
    (PIWIS Tester exits Oil fill mode automatically after 5 minutes)
    The correct oil level is also important to avoid damaging the gear wheels in the
    transmission. There is also an overflow bore for this, which is located on the opposite
    side. The oil level can be checked in the usual way here.
    Oil types/oil fill quantities/oil chambers/change intervals
    Due to high shearing strains that occur in the differential, two different oil chambers
    are used in the Porsche Doppelkupplung transmission.
    The oil chamber for hydraulic oil is shown in red, while the oil chamber for gear
    wheel oil is shown in blue in the illustration below.
    2.95 liters of Mobilube PTX Formula A (SAE 75W-90) GL4.5 are used in the transmission
    for lubricating the gear wheel set. 5.2 liters of Pentosin Gear Oil FFL3 are
    used as hydraulic oil.
    The change interval is 56,000 miles (90,000 km) for hydraulic oil and 112,000
    miles (180,000 km) for gear wheel oil.

    PDK fluids - 2009 MY 997.png
    File Type: .png
    Downloaded: 1 times
    Size: 391.47 KB


    0 0
  • 11/05/14--01:16: Renault master egr off
  • Hello. Can anyoe help with egr off in this file

    0 281 011 940
    8200311550
    29f400

    error is DF241 DF084 or p0400
    Thanks for help Tup

    f400.rar
    File Type: .rar
    Downloaded: 4 times
    Size: 158.64 KB


    0 0
  • 11/05/14--01:19: TOYOTA SPARE PARTS ONLINE
  • DEAR ALL,
    THIS IS A FREE WEBSITE WHERE YOU CAN GET ANY PART FOR TOYOTA WITH PRICE TOO, ALL WHAT YOU NEED TO DO IS TO INTER VEHICLE VIN NUMBER.
    http://www.toyodiy.com/
    PLEASE THANK AND REP IF IT USEFULL FOR YOU

    0 0
  • 11/05/14--01:21: Vito 115 cdi service manual
  • I'm looking for a service manual for a mercedes vito 115 cdi motor type D 646982 ,year 2003 ,basically looking for a wiring diagram .please help me

    0 0

    Just got a new SDConnect and need a heads up on using it with a Xentry 2012/11 software. I have put the ip address but still would not connect to a car for diagnosis. I changed the cal.ini platform to Part_T and still no dice. Please i need some help here, thanks

    0 0
  • 11/05/14--01:33: DAEWOO KALOS IMMO OFF HELP
  • I have a DAEWOO KALOS IMMO problem with 96394271 ecu!
    Anybody is familiar with that immo off?
    Thanks in advance!

    0 0

    Hi

    I am searching for the procedure to calibrate the air suspension of a 2012 Cayenne.
    Has anyone the workshop manual for this including the default heights? PIWIS is available for me.

    Thx Beer

    0 0

    Hi all,
    I must admit, i was stupid enough to to update firmware on my newly acquired MVCI. I got the device with 1.4.8 and updated to 2.0.1, just because i was unlucky setting up Honda HDS.
    When i finally got to a point where the HDS was working fine, except two options. I was not able to connect to IMMO and Keyless Access ECU. Thout might help updating firmware, apparently that didn't help, it only bricked the device.

    Anyway tried to re flash it with 1.4.7 firmware, it flashes ok, but wont connect to a car, when USB plugged in, it lights up Radio led, when applied +12V, power lights up, but USB led doesnt blink. And i can confirm that i was sort of working before, as i have added OEM RC engine starter to my friends accord.

    My device is with RED pcb, v1.3 stamped on it.

    If some one could help me to restore it working position, or maybe someone has the 1.4.8 firmware file, or any hint would be great.

    Here are the pictures of the PCB: 1 2

    Thanks everyone in advance,

    0 0

    Hello Guys.

    It is posible to make immo off in this ECU : 0 281 011 562
    I will get this car tomorrow.

    Regards, Adrian

    0 0
  • 11/05/14--02:08: opel corsa c bodi
  • can anyone calculate pin and make it virgin

    corsa c bodi siemens 313203739 5wk48665.zip
    File Type: .zip
    Downloaded: 3 times
    Size: 357 bytes


    0 0

    dear members.
    if any one have euro ricambi transmissions catalog then pls share.
    thanks in advance.


    (Today 01:23 AM)R.N.A Wrote:  dear members.
    if any one have euro ricambi transmissions catalog then pls share.
    thanks in advance.

    GOT IT IN TORRENT.
    THANKS .

    0 0

    Hi everyone,
    i have image of Xentry connect but i can not recovery this image to my computer? Have everyone can do it?
    Thanks

    dsfadfafadsfsdfa.jpg
    File Type: .jpg
    Downloaded: 3 times
    Size: 92.1 KB


    0 0
  • 11/05/14--22:03: BT Prime-Mover Class 3
  • This is EPC, Service Manual, Electric BT Prime-Mover Class 3 (1994-2002)

    Included model:
    CMX60/80
    CSX10/20/30/40
    PMX45
    HMX/RMX
    TMX
    WRX30
    WSX20/25
    WSX22/30/40

    Dont forget thanks

    class3.txt
    File Type: .txt
    Downloaded: 6 times
    Size: 73 bytes


    0 0
  • 11/05/14--22:16: Mercedes WIS 2014 help
  • Hello all, I'm after a bit of assistance with Merc WIS. I have it installed on a virtual machine (brought it from ebay had to merge all the folders together and away it went) no worries there, but the problem is when I want to search for a particular vehicle (0405 bus 1990 era). It has no workshop data what so ever on it, now if I look up parts for the same vehicle it has all the data there. Is there something im not doing right or is it a common problem? Thanks in advance

    0 0
  • 11/05/14--22:31: yamaha grizzly dash
  • somebody can change dash km from 22827 to 4294 km?
    yamaha grizzly 2007
    thanks!!!!

    s24c02.rar
    File Type: .rar
    Downloaded: 5 times
    Size: 201 bytes


    0 0

    Hello all
    i need add a other(used) key to my Mercedes A 180 W169 2005 year is possible to make this with Star Diagnosis?

    Thanks in advance!

    Best Regards

    0 0

    Hello,

    I'd like to program a new key for a 2009 mini cooper, what's the required tool ? Has anyone programmed a key before, could help me in this matter ?

    Thanks Smile

older | 1 | .... | 379 | 380 | (Page 381) | 382 | 383 | .... | 4895 | newer