I have a thermoking tripac apu. Recently I've been having an issue at startup. It will attempt to start the relay will click and then a send signal to the starter the starter barely makes an attempt at start not even a single revolution and the system completely reboots. After a few attempts it will finally start. It charges normally as it should once started. I checked and rechecked all terminal connections from starter to alternator everything is tight nothing rubbed down. All grounds right and look fine. It attempts start up and after signal is sent just reboots. No codes are present either.
I have problem with Peugeot 308 1.6 hdi 109HP edc16c34.
The car has removed dpf and tuning was done, but after doing the car the car does not drive almost anything better compared to the series and a lot of consumtion around 11-13l / 100 km.
The car has now saved the original file with dpf and egr disabled without tuning .....
The car has been replaced: turbo after regeneration and turbo control, flow meter, corrections on injectors are normal.
Unfortunately, the car still does not go well ...
Recently, about a year after switching off dpf and egr, a message about a small amount of add-on fap has been shown on dashboard and there is an error in engine ecu from the add-in pump.
I have coded the filter with bsi - the message on the board is gone, but the error in the ecu associated with the add-on remained.
Could you please check these files and help me?
Thank you greetings
I attach the original file from this car, and the file with dpf and egr off after tuning, and the oryginal file with disabled dpf, egr without tuning - this file is now in the car.
peugeot 308 1.6 hdi 109ps ori-dpf_off_egr_off_tuning.rar
peugeot 308 1.6 hdi 109ps ori-dpf_off_egr_off.rar
peugeot 308 1.6 hdi ori.rar
Hi I'm trying to find a immo emulator for a KIA 2.9 crd 2005-6 its have a Delphi ddcr R0410C187A ecu , problem sometimes the immo end glow light don't come on when I give ignition end its not starting the car, but when come on the lights its start. So if somebody have to sell emulator for this type ecu please send me a pm with price end delivery cost to Germany. Just working solutions I'm interested. Thanks
Hi, I need dump for Jeep Cherokee 7961m 51 HTAES.
Any version upgrade 38.500.010
I have tried several finished files does not work. It must be from a BMW 525d E61 163HP switch. The ones I have are most likely from an automatic. Can one edit my file on Stage1+++ ?
Any version upgrade 38.500.010 perfect
hi, i'm looking for immo off for hyundai Atos
ECU : 39110-02740 CE6
HELLO EVERYONE !
CAN SOMEONE HELP ME TO RESET HOURS ON HONDA QUAD BIKE FOREMAN 500, 93C66 HAS 2716.0 HOURS, NEED 1000 HOURS
Can someone share Toyota Avensis ADT271 89663-05780- original dump
I have audi A6 2.4 , that turns on the check control, registers the code P0431, I would like to remove it
ecu motronic ME7.1
anybody can help me?
thanks you very much in advance
need DPF off for this Outlander 2012
DENSO RA6 KTAG P 324
ECU HW H15WRA6
Thnx in Advance
I SEARCHED FOR CODE K32 IN EZS213.....BUT THERE IS NO SUCH LIKE THAT
I WOULD LIKE TO ADD ATIVE LANE CHANGE ASSIST TO W213 THAT ALREADY HAVE P20.
DOES ANYBODY HAVE IDEA OF IT?
I am looking for MACAN 2.0 SIMOS 18 - 95B906259C-0002 ori.
Thx in advance!
Hi .Looking for Actia Passthru + XS manual with DB 25 connector pinouts . Maybe anyone have old install CD .
Having problems with this ecu, cannot get rid of the C1511-005 code, i would like to make it virgin if possible and recode again to car.
Here is 24C02 dump.
thanks in advance.
It is from Mercedes G 270 CDI, 463.322, ESP+BAS ecu 0265109495.
Is it possible viginize? Or i am asking an impossible like a fool?
I SEARCHED PARAMETER FOR 891 PREMIUM AMBIENT LIGHT(MULTI COLOR) IN EZS213.....IN VEDIAMO. BUT THERE IS NO SUCH LIKE THAT.
I WOULD LIKE TO ADD THAT NEW EFFECT MULTI COLOR AMBIENT LIGHT OF 2018 TO W213 2017 THAT HAS CODE 877
DOES ANYBODY HAVE IDEA OF IT?
I CHECKED CAR THAT HAS CODE 891 OUT...........BOTH OF CODE 876 AND CODE 877 ARE JA ACTIVE
I need CAT off on file attached please (downpipe installed), my swiftech dongle just crash...
Is MED 17.5.25 for golf VII 1.4 TSI CZDA (stage2) read with flex.
If you rae this tuning file ( stage 2) will be nice also
Thank in advance
Does anbody have solution to Chevy spark 2012 continental D52 immo off?
I only have kemsko in my software which doesnt work