Articles on this Page
- 07/13/19--03:50: _Pin from dump bsi p...
- 07/13/19--03:54: _w20e eis data
- 07/13/19--03:58: _ford hs mca2 code pls
- 07/13/19--04:01: _need pin outs for a...
- 07/13/19--04:19: _CAT C7 help please ...
- 07/13/19--04:22: _6WB Retrofit
- 07/13/19--04:51: _VW Crafter 2.5 EDC1...
- 07/13/19--04:53: _A4 2008+ dash
- 07/13/19--04:55: _Clio3 RS 2l 16v val...
- 07/13/19--05:01: _722.9 oil pan torque
- 07/13/19--05:04: _I sell my BITBOX (h...
- 07/13/19--05:09: _Steering wheel retr...
- 07/13/19--05:13: _DTNA connect
- 07/13/19--05:17: _pin code from instr...
- 07/13/19--05:19: _Bmw Road map for Ca...
- 07/13/19--05:31: _W212 Sidemarker dis...
- 07/13/19--05:55: _Citroen Berlingo 20...
- 07/13/19--06:18: _Punto Evo Multiair ...
- 07/13/19--06:27: _need vehicle order ...
- 07/13/19--06:39: _ORIGINAL FILE
- 07/13/19--03:50: Pin from dump bsi peugeout 206
- 07/13/19--03:54: w20e eis data
- 07/13/19--03:58: ford hs mca2 code pls
- 07/13/19--04:01: need pin outs for accelerator position sensor
- 07/13/19--04:19: CAT C7 help please uncommon fault.
- 07/13/19--04:22: 6WB Retrofit
- 07/13/19--04:51: VW Crafter 2.5 EDC16CP34 2009 remove speed limit
- 07/13/19--04:53: A4 2008+ dash
- 07/13/19--04:55: Clio3 RS 2l 16v valeo S3000 file
- 07/13/19--05:01: 722.9 oil pan torque
- 07/13/19--05:09: Steering wheel retrofit but vibration motor not working
- 07/13/19--05:13: DTNA connect
- 07/13/19--05:17: pin code from instrument
- 07/13/19--05:19: Bmw Road map for Caribbean/jamaica
- 07/13/19--05:31: W212 Sidemarker disable
- 07/13/19--05:55: Citroen Berlingo 2015 tailgate lock disable ?
- 07/13/19--06:18: Punto Evo Multiair bosch 380cc injectors scaling
- 07/13/19--06:27: need vehicle order please
- 07/13/19--06:39: ORIGINAL FILE
Hello guys i need pin code from bsi dump peugeout 206 1.6hdi 2001 year 95160 eeprom
hi i have w203
209 545 05 08 eis type
i think data are corrupted
any help please
Hi i need code for ford radio navigation HS mca2 , 815 C7E3F0965 C 0704773 , 7 612 330 965
I need to find out pin outs for honda accord euro 2005 model accelerator position sensor.
If any one have pin outs for this please share.
Sensor connector has 6 wires. (photos attached)
Have a CAT C7 in a drill rig.
Engine starts and runs as long as the key is in the crank position. If you hold it in the crank position and disconnect the starter motor start wire the engine will run.
Soon as the key goes from the crank position to ignition the engine dies (keyswitch and power ok).
Power, earth ignition to ECU ok.
Programmed a good donor ECU with no difference.
Only issue I can find is the canbus has a fault and it prevents us connecting the laptop.
Has anyone had a similar issue?
Sent from my SM-G965F using Tapatalk
IF SOMEBODY NEEDED 6WB/6WA VIRGINE I CAN MAKE FREE FOR MHH MEMBERS,
-POST 160D AND 93520
-PM FOR PASSWORD
If you need it - push buttons Rate (Reputation) and Thanks, and write on this thread for asking pass.
160d & 93520 VIRGIN.rar
Hello everyone can someone please remove the speed limiter on this file?
Thank you in advance
Anyone can point me in the direction of a reasonable priced tool that can do this dash through obd for mileage adjustment?
Got a genuine micronas by obd tool from xhorse but it seems i cant update it anymore, nor find any support. This seemed the safest way.
Also got carprog 8.21 online, seems to read the mileage correct but i dont dare to try to change it.
Any other tools, or is carprog safe enough? I dont do this for making money, thats why im asking for a decent priced tool.
I know the expensive, good working tools
Please need help with original map file for s3000 or virgin file,because the actual map is a mess and car do not start ,too much injected fuel.
Thanks for your help
Sent from my CLT-L29 using Tapatalk
I am planning to do my own gearbox oil flush on my car.
I saw that the screws to pan are 4nm +180deg, from your experience can I just torque them to 8nm or 9nm or how is that 180deg translated in Nm?
i sell my BITBOX ( software & hardware )
to chiptuning FULL OBD on BMW activate
very good tool without annual subscription
use on E , F & G series
covered all benzine & gazole
working very fine
i sell because now i have Kess original
check screen to see option activate
price via MP
I retrofitted steering wheel (+ airbag) and steering column switch. Everything is working except Lane Change Assist. Xentry quick scan showing vibration motor has malfunctioned under steering column module and MPC camera. Upon visual observation I noticed that my old prefacelift column switch had 8 pins, while the new facelift column has 8+2 pins.
My old 2012 W212 Steering Wheel: A172-460-2803-9E38
My old 2012 W212 Column Switch: A212-900-3103-9051
My new W218 Steering Wheel: A000-460-4203-9E38
My new W212 Column Switch: A212-900-3920-9051
Both old and new wheel + column have similar compatibility: w/o Adaptive Cruise, non-heated steering wheel, w/Lane Keep Assist
Does anyone know how do I make the vibration motor work?
I appreciate any input. Thank you!
Does anyone have a DTNA Connect user name and password that they might share? Can no longer access DD info without them. Thanks.
Hi please pin from vectra c instrument
I was wondering if the Caribbean is included in north America maps or south america maps at all?
I know North America for NEXT Incudes Mexico and Puerto Rico but not sure about Jamaica
If anyone knows please let me know
Sent from my SM-G955F using Tapatalk
I know this topic has been previously discussed but it's not specific.
I want to disable the side markers on my pre-facelift W212. I have toggled pretty much all lines under 45.VCD_Parameter_Sidemarker in SAMF_172 but unsuccessful.
Changing country under CGW from USA to Rest of the world works but I want to keep USA and disable it through front sam only.
I'm attaching screenshot with current settings on SAMF_172. Any help is appreciated.
Can this stupid option be disabled ? So anytime when I drive over 10 kmh it locks rear doors and it does not unlock even when I turn off the car. It is 2/3 seater and closed rear part.
Can it be disabled and how ? Holding Lock button for 2-3 sec until it beeps in the cabin acitivates only door locks automation but does not touch rear doors.
Hello, does anyone have a well injectors scaling solution for a Abarth Punto Evo Multiair with a 380cc bosch ev14 injectors?
need vehicle order .xml file for my old ista/p
please i want original file iaw 6lpc.105