Articles on this Page
- 07/15/19--14:00: _ME9.2 BMW 318i dtc ...
- 07/15/19--14:11: _nissan v9x dtc p2002
- 07/15/19--14:25: _Smart opener contro...
- 07/15/19--14:53: _Porsche PIWIS III I...
- 07/15/19--15:04: _ISX swap in Interna...
- 07/15/19--15:19: _NTG ANTHITEFT PIN N...
- 07/15/19--15:37: _DDDL 8.08sp3 KM loc...
- 07/15/19--16:39: _Service Manual 2018...
- 07/15/19--17:28: _PACCAR MX13 DELETE ...
- 07/15/19--17:53: _lancer 2000 dash du...
- 07/15/19--20:29: _New Type Test Platf...
- 07/15/19--20:42: _BMW E60 water tempe...
- 07/15/19--20:47: _volvo bus files B12...
- 07/15/19--20:47: _Ford OASIS
- 07/15/19--20:49: _launch golo 3.0 and...
- 07/15/19--20:52: _need radio pin code
- 07/15/19--22:38: _### Dpf, Egr, Dtc, ...
- 07/15/19--22:38: _help with abs codin...
- 07/15/19--22:38: _607 EDC 15C2 3 PLUGS
- 07/15/19--22:47: _How to load flash f...
- 07/15/19--14:00: ME9.2 BMW 318i dtc delete
- 07/15/19--14:11: nissan v9x dtc p2002
- 07/15/19--14:25: Smart opener control unit - how to connect ?
- 07/15/19--14:53: Porsche PIWIS III Image
- 07/15/19--15:19: NTG ANTHITEFT PIN NEED HELP
- 07/15/19--15:37: DDDL 8.08sp3 KM locked to 1 pc
- 07/15/19--16:39: Service Manual 2018 Multiplex Electrical System (SM034-003)
- 07/15/19--17:28: PACCAR MX13 DELETE EGR DPF
- 07/15/19--17:53: lancer 2000 dash dump need
- 07/15/19--20:29: New Type Test Platform For BMW FEM & BDC by WWW.AUTO-CHIPS.COM
- 07/15/19--20:42: BMW E60 water temperature warning alarm.
- 07/15/19--20:47: volvo bus files B12R 420 mid 128 ishift
- 07/15/19--20:47: Ford OASIS
- 07/15/19--20:49: launch golo 3.0 and Launch Golo carcare in stock
- 07/15/19--20:52: need radio pin code
- 07/15/19--22:38: help with abs coding skoda octavia
- 07/15/19--22:38: 607 EDC 15C2 3 PLUGS
- 07/15/19--22:47: How to load flash files with Volvo PTT 2.7.X.X???
Hi guys i need to delete these dtc 2714 and 2724 from this type ecu :
VIN nr.: BAAT51030яW08175
SW ver.: 1037351566
HW Ver.: 0261209001
SW upg.: 51620000
here is ori file :
bmw e46 ori.rar
after dpf,egr off dtc p2002 still
can some one help with working solution :have tryed others
thanks in advance
NISSAN DTC P2002.rar
The car is a Bmw F11 535D xdrive. I have a broken plug at smart opener control unit 7491439. I do not know how to connect the cables to the new plug. The cable colors are red, brown and orange. Tell me how to connect the cables with the plug.
Thanks and best regards
Anybody have the aomei backupper image of PIWIS III that was floating around a couple months ago? I found a few links for it on mega but they've all been deleted by now.
I have an interesting one on my hands.
I have a customer that brought me a pro star with a blown ISX to swap another ISX (both cm2350) into. I pulled the original ECM and make a template, then put that template into the new engine (on the bench). went to start up the motor after the install and found engine related gauges were not working and check engine light was on with "electrical fault" on the dash. tried hooked up with insite and it wouldnt connect. I unhooked the usblink and checked the resistance across pin C and D on the plug - 120 ohms. I found a corroded wire on the terminating resistor at the def dosing unit, fixed it and check resistance at the plug again. 60 ohms across C and D. I have good power and ground at the plug but insite still wont connected. Tried using Jpro and it connects to every on-board computer but the engine. I pulled the OEM ecm plug off and resistance checked from the plug to pin C and D on the data link connector - both had very close to 60 ohms. hooked up my bench harness (with the ecm on the engine) and it connects no problem.
The problem is obviously on the truck side but with the resistance values looking normal after that resistor was fixed - I really dont know what to check next.
I should mention that when the oem plug is on the primer pump runs and the engine will start.
What am I over looking?
need PIN for HU45
thanks in advance
who can sell me DDDL 8.08SP3 KM locked to 1 pc .. so i can activate several laptops
please pm me
i want to post the service manual but its too large can someone help how to send
Please could you tell me which KESS protocol I could read a paccar mx 2013.
I will thank you very much
I need a dash dump for Mitsubishi Lancer 2000, Yazaki odo
Odo chip - AD09952G
no idea which type need to select on digiprog 3, I tried 93c56, and 93c86 on digiprog 3. But not reading correct mileage.
Could someone please share a dump with 170,xxxkm for me.
When making keys, BMW F series FEM & BDC all need to preprocess the IMMO box.. If there is no test platform, it needs to disassemble and install the control unit in the car back and forth..
Using our test platform can be completed on the bench, It's both economical and convenient.
The wire is made of Japanese material, with built-in start button, indicator light, IMMO box indicator light, very user-friendly design, and most importantly, high quality and low price.
If you interested or you need, please let us know
Can coding or setting water temperature warning alarm on BMW E60?
Hello, who has a file mid 128 on the bus volvo b12r 420 ishift hw 20814550
Looking to purchase/share subscription. Anyone on here sell that?
launch golo 3.0 and Launch Golo carcare in stock
Pls PM me if you want them.
i need honda accord radio pin code
thanks in advance
All solution possible for 25euros
Also offer stage1,2 for all petrol and diesel engines
someone can help me with long codig of abs for ESP MK60EC 1K0907379BJ WITH VIN TMBHT61Z8C2163417,I TRY WITH ESP CALCULATOR FOUND HERE BUT DOESNT WORK THANKS INADVANCE
Good day. PLEASE IMMO OFF PEUG EOT 607 EDC 15C2 3 PLUGS
Hello guys .
I have installed Volvo PTT 2.7 and want to use flash files .
Don't know how to load or how to flash it .
Does anyone have a tutorial for that ?
Will really appreciate it .