Anyone know what frequency is used by Toyota for the remote 'Lock' and 'Unlock' buttons on key fob
Hello mate can anyone help for MB sprinter immo box dump file (Temic. 020 545 56 32 mcu 0d62j. My got corrupt while reading
Hello, Can i ask for help, i need 0km in this file. Is EZS w639 9s12 Thanks
Can I use INPA DCAN cable for updating ECU with WinKFP for updating the VIN too?
help full bdm vectra c 1,9 150km 0281014450
Hi there mates!
I'm trying to make Safe Off in a Smart 450 Grundig radio.
Do you Know how to do it?
I haver calcgen 2009 but no Luck.
Thanks a lot!
I have a clip that always gives drivers instalr failure, until recently worked on xp but recently that only served as a paperweight.
My surprise was when I left a pc with seven on which you install the clip when they buy it for years and prove it works without problems, but change the USB port and install the four drivers to perfection, I created a copy with acronis the I tried it on another pc and the drivers installed without problems.
The problem is that the pc lleba six years without formatted and has more viruses than a hospital.
Could someone with a functional clip create a clean install of xp with seven or drivers of the clip?
Thanks for your time
hi all users
I need dump file Mercedes Benz GS euro 3 am29f200bb
I have worked on 2 identical cars from a customer, were Seat Leons with the BKD 140HP engine.
The ECU files are the same on each, but one car smokes at idle speed, the other is perfect.
I will check soon to see the regeneration status of each, but I believe that the smoking car may be stuck trying to regenerate.
Is there a way to reset this? I have Delphi and gen VCDS.
I'm sure I reset the DPF levels on both cars, the smoking car might have been reset with Delphi, and then checked with VCDS.
Hi friends, I need help setting up a key for a Toyota Corolla 2008, but there is a problem and that is the key that I have is the valet key gray, I have the master key, what I did was buy a blank key on ebay , cut and make the procedure exist, including using the techstream but it says the key is not inserted mastery and leaves me to program, what method I could use to program another key thanks
i have an error with a C4 clone mux. There are symbols on the mux i've never seen like this.
The error appeard "over night", yesterday everything still worked fine.
Attached Screenshots, self test of sd connect says DCDI_eErrorCode=204 (204) error. I found another thread on the forum which says this error means i need to put batteries into the mux. But with batteries there is the same error. Is there a way to fix this?
Thanks for your help.
Hello. Need code for:
7 612 002 092
8E0 035 192 S
Inside radio are 2 flash memory.
I will read it if needed.
Hey I was wondering if there is anyone who can explain to me how I chipping my golf 4 1.9 tdi -00 I have a KWP 2000 I try to read ECU have removed the fuses as it is but it can not be read anyway what do I error mvh Göran
Anyone can help me with calculating checksum on truck temic tricore intel hex files. I have two files both have correct checksum only two changes to file.
i need an IMMO off end the pin for :
0 281 010 361
96 416 076 80
Need help with pin from 307 bsi hc12 ...
I request a DVD with Custom MAP including Romania.
For M-ASK SYSTEMS, BUSINESS SMALL NAVIGATION E60 E61,ETC.
Thanks in advance!
I'm selling my Snap On Modis as I don't use it much these days, Its in VGC comes complete with all the additional leads and 2 Coil pick ups (single and multipack) Current software is 13.2 ,
This is collection only please from South Yorkshire England,
PM for further details
need eprom and flash of ezs number 2115452308. thanks in advance
hi after a bit of advice
wheres the best place to purchase opel scanner lead, so i ca retrieve security code
2006 vectra c 3.0l cdti auto