Quantcast
Are you the publisher? Claim or contact us about this channel


Embed this content in your HTML

Search

Report adult content:

click to rate:

Account: (login)

More Channels


Showcase


Channel Catalog



Channel Description:

MHH AUTO - https://mhhauto.com

older | 1 | .... | 4519 | 4520 | (Page 4521) | 4522 | 4523 | .... | 5081 | newer

    0 0

    looking for the VAG MED17 BOSCH Founction sheet
    i can pay or exchange for it.

    0 0

    I have bmw 5 series,getting fault of 0093f9 sgm-sim control unit fault,i just replaced control but still reading same fault.someone help me please,i just replaced with used one


    Sent from my iPhone using Tapatalk

    0 0

    Hi.

    Looking for stock dump from BMW F30 330i b48 
    mg1 ecu

    0 0
  • 09/13/19--09:11: DQ 250 mechatronic fix..
  • hello guys maybe this will help someone..we had dq250 mechatronic problem on golf 7 1.6 tdi,error was lost of pressure..after lot of searching we saw that housing of mechatronics has crack where the battery goes and it is very small.fix was very easy Lithuanian firm is producing part that can fix mechatronics and it is isnt expensive even..golf is working even better then it was before..i hope that it will help to someone cause new mechatronic is very expensive and vw didnt expect to fix it,just to buy new one.i will post a link of video

    https://mail.google.com/mail/u/0/#inbox/...rojector=1

    0 0

    Hi please I need virgin ecu for Megane 1.5 dci


    SID 301 S122326109 A 8200565863 8200592611


    Thanks in advance to help me.

    .zip

    SID301 MEGANE AM29BDD16G EXT.FLASH ORG.zip

    0
    430.35 KB

    0 0

    Hello,
    Can anybody delete crash data from this 610901600 ecu?
    Thanks in advance!

    .zip

    Lag3_VA_crash_610901600_95640.zip

    0
    1.86 KB

    0 0
  • 09/13/19--09:45: tuning 6HP audi
  • Hello

    it is possible tune?
    and possible write by odis?

    thanks

    .rar

    4F2910156T__0050.rar

    0
    566.91 KB

    0 0

    hello . I am looking damos or map pack vw passat B6 BMP 2.0   TDI mechanic gearbox edc16u 34 03G906021AB
    sw 382417. Thanks 

    0 0

    my softwares don't suporting this model so need help. need check my dump and if need virgine 
    mercedes s 500 from 2002 chasis w220. ecu bosch 0 261 207 121
    A1131530079

    .rar

    ECU 5P08 ORG.rar

    0
    431 bytes

    0 0

    Hello
    Can somebody give me pin from dump

    Thanks

    .rar

    cim.rar

    0
    736 bytes

    0 0

    MB E220 W211 2008 was not possible to reset the service. I think the kilometers are changed. Can anyone tell me how this can be done? How can I make these settings with MB Star C4 / C5 in ASSYST PLUSS? Please help. Thank you.

    0 0

    hello, I need to virginize eeprom box instruments mercedes B180cdi 2005, and set km to 0 and it does not allow me to adapt with star diagnosis, in most Mercedes bodies I do so and if I can, in this I can not cut communication with ezs so in the box it marks me ----.

    Can anyone help me? Thank you.

    0 0

    HW: 0281011914

    SW: 1037379357

    Engine: Z19DT

    Opel Vectra C 1,9 CDTI 120HP

    0 0

    Someone before me replaced ecm and every other module on this vehicle from donor vehicle. Vehicle is keyless entry. After that immo light came on with code in vehicle theft deterrent module for for vin check not recieved from ecm. At this point i thought easy. Just reprogram tdetmod to vehicle. I have mdi and sps online. So i enter theft deterent link and relearn and all goes well. Remotes work, programming completes and it says that everything is linked etc. But as soon as i cycle key immo light starts blinking and no start. Hoping this happened to someone else. Thinking that signal between ecm and tdmod is not send or recieved. Checked can high and low,also gmlan. Checked vin nr in all modules. They are all the same. Any thoughts



    Read more: http://prodiag.boards.net/thread/728/chevrolet-captiva-diesel-smart-service#ixzz5zQZOh3o5

    0 0

    Need chassis and engine service manual for Hino2003 Chassis and Engine. Thanks

    0 0

    Hi,

    i changed the two mass flywheel to one mass flywheel, because vw has problems with it and build new parts.
    the parts from the kit 6c0 198 105 (one mass flywheel, clutch, drive shaft right side).

    vw told me, i must do online correction for this kit.

    somebody can help me shortly?

    i have odis and certificat.

    0 0
  • 09/13/19--11:16: Vw craffter
  • Hello everyone help with dashboard of a vw craffter 2.5  immo off


    (2 minutes ago)Caracol Wrote: Olá pessoal, ajude com o painel de um craffter vw 2.5 immo off
    Hello everyone help with dashboard of a vw craffter 2.5 immo off

    0 0
  • 09/13/19--11:25: iveco immo off
  • hi. can sumone do immo off iveco daily 2.8 0281011228 eep95640
    thank you.

    .rar

    iveco 95640 eep.rar

    1
    427 bytes

    0 0
  • 09/13/19--11:44: PHOENIX l12 problem
  • I have a problem in the ecu de john deere L12, the diagnostic tool shows (dtc 2000.06 internal failure of the ECU. Injection pump / control unit - short circuit, current too high) I have reviewed the ecu and look at the pinout a bit in disrepair, I returned to resolded, mount again the ecu in the vehicle but he still shows the same error, can someone help me, how can I find the short circuit?

    .jpg

    IMG_20190913_182820.jpg

    1
    311.66 KB

    .jpg

    IMG_20190913_182826.jpg

    1
    354.87 KB

    .jpg

    IMG_20190913_182833.jpg

    1
    269.98 KB

    .jpeg

    received_384201022257479.jpeg

    1
    84.66 KB

    0 0

    Hi all,

    Please need help to read zadi 24c04 in my Ducati diavel. This is new model tmpro don't have diagram.
    Thks.[Image: 72828e808a9129c7e5ad2e8442cfa5f7.jpg][Image: 1ab20f9080bed8dd9f990af6617e2449.jpg][Image: b0aed0fdcb0767946b5613209838db54.jpg]

    Envoyé de mon BV9500Pro en utilisant Tapatalk

older | 1 | .... | 4519 | 4520 | (Page 4521) | 4522 | 4523 | .... | 5081 | newer