Quantcast
Are you the publisher? Claim or contact us about this channel


Embed this content in your HTML

Search

Report adult content:

click to rate:

Account: (login)

More Channels


Showcase


Channel Catalog



Channel Description:

MHH AUTO - https://mhhauto.com

older | 1 | .... | 4787 | 4788 | (Page 4789) | 4790 | 4791 | .... | 5109 | newer

    0 0
  • 11/12/19--13:21: honda frv flash file
  • Hi, i'm looking for org flash file for honda FRV 2,2cdti 2006y

    ecu bosch edc16 0281013521 sw 1037528450 

    can someone help me thanks and regards

    0 0

    Hi, can I get information on cloning a body from the old Fiat 600?

    Thanks

    .jpg

    body siemens.jpg

    1
    385.35 KB

    0 0

    Hello

    i want to build a Discover media in an T6 and Caddy 4 .. On both cars i need can filter or MIB patch board?

    thanks

    0 0
  • 11/12/19--13:39: CM2250 Room Boot
  • Hi, anyone have room boot pinout for cummins cm2250?
    thanks

    0 0

    Peugeot 307 dump st95128 pin needed Pls Help!!

    .rar

    st95128.rar

    0
    2.38 KB

    0 0

    question
    if change new actuator for turbocharger engine 3.0 diesel, can be done with odis or need vas 6395?

    0 0
  • 11/12/19--14:35: nissan patrol 2005 immo off
  • HI GUYS NEED IMMO OFF FOR nissan patrol 2005
    ECU Hitachi kz
    part no 23710 vd110
    eeprom 93c46

    .rar

    93c46.rar

    1
    159 bytes

    0 0
  • 11/12/19--15:35: Ews3 and dde3 sync
  • Hello i have read the dumps is isn correct? 
    84 0E
    i need also to sync from dde ee to ews if possible thanks..

    .zip

    e46 edc15.zip

    0
    944 bytes

    0 0

    Can anyone to disable heating of the lambda ?

    .zip

    flash.zip

    0
    664.56 KB

    0 0

    Hi Friends!!

    Can someone help me?

    I need original file for Fiat Punto Tjet
    0261s06638

    Tks in advance.

    Regards for all.

    Pires

    0 0

    so i have a 2016 audi S7 and the transmission has been nothing but problems in it. the car has 52,000 miles on it and its already on its second transmission that is already giving me problems. i have the dreaded dash errors where reverse is locked out and the others less where the transmission stops functioning completely. sometimes it will put an error up on the dash and it will skip shift on one gear stack which i normally lose gears 2-4-6-R but if i shut the car off, start it back up all the gears work fine for a little bit than it comes right back. also recently i noticed that it has a hard time shifting into 5th gear as well. i enabled the actual gear number on my dash through VCDS so i could keep track of what gears where giving me problems and when it shifts 5th gear sometimes it will show D5 - D - D5. sometimes it will go into 5TH and other times it will skip 5th and go to 6th. it does this no matter if its in sport mode, drive or manual shift mode. i figured the clutches are fine because when it shifts right it has very positive gear engagement like if its shifts 1-3 gears fine why would it slip and hesitate for gear 5? also there was 3 times where the dash warning came up that the trans malfunctioned but i could keep driving but the problem was that the car lost all throttle response and stayed locked in first gear till i stopped the car, put it in park, shut it off, waited 10 seconds, than restarted it again and it would drive OK for a little while. basically there is no way of predicting when the transmission will act up as it is completely random. transmission fluid levels are good and the fluid is clean still, temperature does not affect when it happens as well. 

    these are the common fault codes i pull from the transmission with VCDS. 
    24380 - Gear Selector 
              P187F 00 [108] - Position Deviation
              Intermittent - Confirmed - Tested Since Memory Clear
                Freeze Frame:
                        Fault Status: 00000001
                        Fault Priority: 6
                        Fault Frequency: 12
                        Reset counter: 40
                        Mileage: 85772 km
                        Date: 2019.11.05
                        Time: 16:45:48

    24379 - Gear Selector 
              P187F 00 [104] - Position Deviation
              Intermittent - Confirmed - Tested Since Memory Clear
                Freeze Frame:
                        Fault Status: 00000001
                        Fault Priority: 6
                        Fault Frequency: 11
                        Reset counter: 40
                        Mileage: 85786 km
                        Date: 2019.11.05
                        Time: 17:11:57

    24378 - Gear Selector 
              P187F 00 [096] - Position Deviation
              Intermittent - Not Confirmed - Tested Since Memory Clear
                Freeze Frame:
                        Fault Status: 00000001
                        Fault Priority: 6
                        Fault Frequency: 2
                        Reset counter: 38
                        Mileage: 85806 km
                        Date: 2019.11.06
                        Time: 14:46:09

    24377 - Gear Selector 
              P187F 00 [096] - Position Deviation
              Intermittent - Not Confirmed - Tested Since Memory Clear
                Freeze Frame:
                        Fault Status: 00000001
                        Fault Priority: 6
                        Fault Frequency: 5
                        Reset counter: 40
                        Mileage: 85775 km
                        Date: 2019.11.05
                        Time: 16:51:53


    These are the ones that i have been getting more frequently now and i have stopped driving the car since i got these. 

    18765 - Valve 3 in Transmission Part 1 
              P17D4 00 [101] - Mechanical Malfunction
              Not Confirmed - Tested Since Memory Clear
                Freeze Frame:
                        Fault Status: 00000001
                        Fault Priority: 2
                        Fault Frequency: 1
                        Reset counter: 40
                        Mileage: 85628 km
                        Date: 2019.10.29
                        Time: 22:19:20

    18444 - Clutch 1 
              P17CF 00 [096] - Slippage too High
              Intermittent - Not Confirmed - Tested Since Memory Clear
                Freeze Frame:
                        Fault Status: 00000001
                        Fault Priority: 2
                        Fault Frequency: 2
                        Reset counter: 39
                        Mileage: 85523 km
                        Date: 2019.10.28
                        Time: 22:51:17

    18766 - Valve 3 in Transmission Part 2 
              P17D5 00 [104] - Mechanical Malfunction
              Intermittent - Confirmed - Tested Since Memory Clear
                Freeze Frame:
                        Fault Status: 00000001
                        Fault Priority: 2
                        Fault Frequency: 2
                        Reset counter: 40
                        Mileage: 85628 km
                        Date: 2019.10.29
                        Time: 18:55:19


    i dont know how to interpret any of these to start with diagnosing where the problem is exactly. is this a mechatronic problem, a wiring harness problem and will audi's "repair kit" fix it, or the transmission is just junk and needs to be replaced again. any input on where to start diagnosing this would be great. Really hating the decision on buying this, i should have just kept driving my 1995 S6 avant as the good old turbo 20V 5 cylinder never lets me down and the old 01E 5 speed is indestructible. thanks everyone!


    oh and i forgot to mention that the car has stock ECU and TCU reflash. it used to have APR stage 2 ECU and TCU reflashes but after its visit to audi for transmission 2 it was put back to stock i and i never had the APR dealer put the software back on it.

    0 0
  • 11/12/19--16:39: AUDI SQ5 2014 3.0
  • Hi we have a Audi SQ5 2014 3.0  with a G70 MAF sensor fault implausible signal P0101

    Driving at about 55-60 mph constant code will appear

    Air filter replaced
    Intake system smoke tested no leaks
    Turbos both have had cleaner through them
    EGR taken off stripped and cleaned
    Wiring checked from MAF to ECM OK
    Checked for correct software in ECM been told its original 

    Any HELP please

    0 0
  • 11/12/19--16:39: Autorepairmanuals.ws
  • To whoever owns this page. I know you crawling all over this page. Please think about removing the trojan from your page

    https://sitecheck.sucuri.net/results/Aut...manuals.ws
    It's got a known javascript trojan dropper. Do not go there if you don't love for your shit to get jacked.
    Don't know who owns it, nor care. Just so you know. You need to clean up. You look'in a little junky!

    0 0
  • 11/12/19--16:54: CUMMINS CM2350
  • Hello, I am working on a ISX15 CM2350 X101 and its throwing codes: SPN 1145, SPN 1144 FMI 7 etc.

    This fault code is intended to identify fueling quantity and timing issues
    Cylinder number X fuel injector failure

    the codes stand for or "Injector solenoid driver cylinder x - mechanical system not responding or out of adjustment"
    the engine runs smooth, I checked intake and exhaust valve lashes and they're all OK
    Did Injector Leak test and all is OK
    Did Injector Performance Test and all is OK
    There are 0 signs of faulty injectors or a bad tune up/valve lash adjustment etc.
    Checked Calibration/ECM Code and its all original

    Has anyone experienced these codes because its reading em for Cylinder/Injector 6,5,3,2,1 and there doesnt seem to be any issues with any of those injectors/cylinders.
    -edit : No black smoke or unusual engine operation.

    Thanks in advance!

    0 0
  • 11/12/19--17:10: Isuzu NQR Service Manual
  • Hi all, I am looking for a service manual or wiring diagram for an Isuzu NQR 450 Turbo 2001 model, can anyone help me?

    Details of truck if needed are Model: NQR498A  VIN: JAAN1R70RY7100359  Year 2001

    Thanks

    0 0
  • 11/12/19--18:24: OLD DTS monaco for win XP
  • Hello Gents,

    After lots of issues trying to connected to W903 and W906 I want to setup a machine with Monaco only and go from there however I am wondering what is the CORRECT version of Monaco and vediamo from this time 2003? and do you know where I can get the software? and then will it work with a C4

    Thanks.

    P.S anyone with experience on faulty C4 please let me know I wish to speak with you about repairing BPS? on my c4

    0 0
  • 11/12/19--18:30: Webasto.
  • can anyone point me in the direction as to what i need to work with webasto heaters, have alot of locals wanting me to work on them , mainly dozers and tractors.
    Thankyou.

    0 0

    Hi, I programmed and encoded most modules including DME with ISTA D due to strut replacement on a 2015 BMW 650i. Now I have 2 lean codes in DME P0171 and P0172 and I didn’t have check engine before, any help would be appreciated. Thanks

    0 0
  • 11/12/19--19:16: CALTERM CM2350 BHO, BHV ECFG
  • I need a cm2350 bh cfg file? Could you help

    0 0
  • 11/12/19--19:21: Audi S7 crash data clear
  • who can clear it?

    .rar

    Audi S7.rar

    0
    3.17 KB

older | 1 | .... | 4787 | 4788 | (Page 4789) | 4790 | 4791 | .... | 5109 | newer