Having a Detroit 60 Series ddec4 version 42.Have removed egr and vnt.Everything ok just oil pressure sensor reading low. Check manually and found pressure 50 psi as compared to engine sensor reading 28.0.
any suggestions and ideas .
Please little urgent.
I have this message up on the original three I made and thought I would just post it to raise more awareness about it
The body computer is working properly again!!
I ended up using the spare body computer I had and moving over 3 components from the original body computer to the spare body computer to make it match the car.
I only knew the components to move over after researching the codes and id's on the chips themselves then just taking a guess.
The link below is the last movie I made and uploaded to my YouTube channel.
I need a help, about how I will change de Power of Caterpillar D9 Tractor, see attached a table of parameters into the ECM, so same people told me tha if I change the Full Torque Setting (FTS) parameter I change de Power, in this case the value of FTS it´s -66 to 410 Hp, do you know what´s the new value to 350 Hp of Power for exemple?
Have any more parameters to change or just it´s FTS?
Hello! I'm swapping a fuel pump of a Y20DTH engine, PGS16 and i need to reset and program with my car. The problem is that i dont have the carpass of the donor vehicle (was destroyed in a crapyard 1000km's from my home), and my carpass too. What can i do? i only have the donor's VIN
I have install DAVIE 5.6.1. Runtime
with WKS code found on this forum, with Davie expiration extender. With all these or without i get an error 302.144 when DAvie attempt to connect to the vehicle.
No 300.02 error only 302.144 only when tries to connect. ANY Ideas?
* Runtime 5.6.1.
Windows 7 32bit