Anyone have the following flash files for a c7? 300-0456, 300-0458
Chrysler Neon 2.0 16 v 1997 y. immobiliser was blocked becouse owner lost an RF transmiter. In immo / Rockwell/ pin 22 of procesor motorola /28pins/ must to be connected to the ground thru 33 ohm resistor.
Problem solved ! You dont need any more rf transmiter to start the car.
Hi,i need help about etacs+immo swap from other vehicule because(water intrusion),now etacs and fast immo module have trouble codes B2206 chassis vehicule id mismatch the car start and run fine but on cluster show always error,i want to know if someone had this issue because i try to rewrite vin but scan told vin is already there if someone have info for chip or processor location and id for blanking or rewrite by dump i very appreciate it,thanks in advance.
can someone explain how to change language in (on) SD-Connect...!?
My sucessfull install of 07_2013 was a little bit mixed in language...
I changed language from SDnetControl and SDconnect Toolkit from english to german...but on SDC it shown always english language
I have broken SDC, with german language...
someone know a guide..trick to change language on SDC-Display
Thanks in advance
Hi I need ori file
[undefined=undefined]Hello please i need pin code for peugeot 407 year 2006
Eproom is 95128
I need full bdm dumps for one of 3 ecu units for mercedes 115 cdi year 2005:
-A 646 153 27 91
0 281 012 067
-A 646 150 07 91
0 281 012 355
-A646 150 31 78
I have replace a faulty automatic gearbox by a manual one and now the car does not start.
I guess I have to modify this information inside the EWS (from GT1 I can see that the position of the selector lever is on driving position).
I may also remove the GS from the system. But when I physically remove it, the DME and the EWS are no more visible.
So m8, please telle, me:
- is there some cabling modifications to undertake between the DME and GS cables before removing GS?
- Or may I just modify the gearbox inside the EWS?
- Between Xprog-m and Carprog what tool is the best to modify ews?
Tools I have:
- BMW/GT1, BMW/SSS
Tool I dont have
- EWS Editor
iv come across carlabimmo.com
does anyone know of this site seems a bit expensive tho ?
can anyone gime any info were mileage is stored on 2008 vauxhall insignia please
what software do i need to reprogram odometer on 2012 international prostar truck.
i had to replace instrument cluster and now mileage doesn't match.
thanks in advance and regards
Somebody knows how to do IMMO OFF in ECU of KIA Shuma 1.5 16V 2000year?
There is problem with synchro of keys but DLC connector under hood is dead so i can't make it with diagnostic equipment and want to do IMMO OFF in other way. Is there any tool to do this? domeone did it before? regards
hello all guy's. i have one ecu from alfa romeo 156 with number's
M 1.5.5 i need to immo off for this ecu. anyone guy know how to read and how to write?i have galeto 2 MPPS V12 european.
Hi to all guys!
I am searching to buy a tool for odometer so i want to buy digiprog III clone...Can it do the cars that described ??and can it change the km in bmw x5 E53 and mercedes w211 and 203???
Iv been trying to learn the software, using Nefmoto for flashing. I need to eliminate my O2's and to date have only managed to brick my ecu. I sent it out to be fixed, and its now back but I need to better understand wxactly how to use it. Im pretty lost. Any experienced users have 10 minutes to explain on the phone what I need or should have to successfully flash my RS6?
Thanks for any help...
SERIAL NUMBER: LA215000487708
Anybody have level 2 version of DDDl 7.10, all I have is level 1
i have cummins inpower 9.5 program and i need unlock key for it
so if any one has crack for this program ,share it please